User's Manual

Talkie Tooter 1100 User Manual 11
ACME 3 SPEED SLACKPULLER
The transmitter is worn around the waist using the attached belt. To operate the
transmitter it must be tilted so the antenna end is pointing up. The transmitter has two
push buttons. The button closest to the antenna is the UP or TOP button. The other
button is the DOWN or BOTTOM button. Send a signal by pressing either button for at
least 1/10 of a second, but less than 1 second.
TOP BUTTON

TOGGLE SLACKPULLER SLOW / STOP / CLOSE SKYLINE CLAMP

TOGGLE SLACKPULLER MEDIUM

PULSE SLACKPULLER MEDIUM IF SLACK IS OFF AND SKIDLINE IS OPEN

SLACKPULLER SLOW IF SLACKPULLER FAST ON

TOGGLE SLACKPULLER FAST

PULSE SLACKPULLER FAST IF SLACK IS OFF AND SKIDLINE IS OPEN

YARD/HAUL

START ENGINE
BOTTOM BUTTON

STOP

CLOSE SKIDLINE CLAMP IF BOTH CLAMPS ARE OPEN

OPEN SKIDLINE CLAMP IF ALL OUTPUTS ARE OFF

CLOSE SKYLINE CLAMP IF BOTH CLAMPS ARE OPEN

TOGGLE SKIDLINE CLAMP

TOGGLE SKYLINE CLAMP

OPEN SKYLINE CLAMP

OPEN SKIDLINE IF SKYLINE CLAMP OPEN

KILL ENGINE ACME – VER. 6
 Is a quick (1/4 of a second) press and release of the button.
Is three times as long as a .
Transmitter antenna must be pointed up to send signal!
DISCONNECT RADIO WHEN JUMP STARTING OR WELDING ON MACHINE.
CAUTION!!
WIRING INFORMATION FOR THE YARDER TRANSMITTER
CONNECTING WIRES INCORRECTLY WILL CAUSE DAMAGE TO TRANSMITTER
• 24 Volt System: Connect the white wire ONLY to 24 volts and the black wire to battery
ground.
• 12 Volt System: Connect the red wire ONLY to 12 volts and the black wire to battery ground.
• Note: Green wire is not used.