User's Manual

Talkie Tooter 1100 User Manual 7
TRANSMITTER OPERATION
EAGLE VI HYDRAULIC OR SUPER EAGLET SLACKPULLER
The transmitter is worn around the waist using the attached belt. To operate the
transmitter it must be tilted so the antenna end is pointing up. The transmitter has two
push buttons. The button closest to the antenna is the UP or TOP button. The other
button is the DOWN or BOTTOM button. Send a signal by pressing either button for at
least 1/10 of a second, but less than 1 second.
TOP BUTTON

CLOSE SKIDLINE CLAMP IF SKIDLINE CLAMP AND SKYLINE CLAMP OPEN

STOP / ALL OUTPUTS OFF

SLACKPULLER




SLACKPULLER FAST
 
SLACKPULLER REVERSE
HOLD PULSE SLACKPULLER IF SKIDLINE CLAMP OPEN

START ENGINE
BOTTOM BUTTON
HOLD
POWER DOWN

OPEN SKIDLINE CLAMP IF ALL OUTPUTS ARE OFF

OPEN SKYLINE CLAMP

OPEN SKIDLINE CLAMP ONLY IF SKYLINE CLAMP OPEN

KILL ENGINE
 Is a quick (1/4 of a second) press and release of the button.


 Is three times as long as a .
Transmitter antenna must be pointed up to send signal!
DISCONNECT RADIO WHEN JUMP STARTING OR WELDING ON MACHINE.
CAUTION!!
WIRING INFORMATION FOR THE YARDER TRANSMITTER
CONNECTING WIRES INCORRECTLY WILL CAUSE DAMAGE TO TRANSMITTER
• 24 Volt System: Connect the white wire ONLY to 24 volts and the black wire to battery
ground.
• 12 Volt System: Connect the red wire ONLY to 12 volts and the black wire to battery
ground.
• Note: Green wire is not used.