User's Manual

1669-R RFD OPERATOR MANUAL REV. PP1
48
The Test Box will arm and fire a Remote Unit connected to the probe. The two leads
from the probe must be connected to the Remote binding posts for the arm voltage to
be measured. The “015” is the amount of time remaining in the Arm / Fire test. This
number will count down to “000”. The Remote will then be fired.
The Test Box will automatically step to the next message.
This message show the actual armed voltage measured, and the minimum armed
voltage level that is normal.
The Test Box will automatically step to the next message.
This message displays while the Test Box loads down the battery of the unit connected
to the probe. This is done to get a more meaningful measurement of the battery status.
The Test Box will automatically step to the next message.
This message shows the battery voltage for the unit connected to the probe while the
Test Box loads that battery. The Low Battery for the Unit is also displayed.
The Test Box will automatically step to the next message.
Armed Voltage 27.16
Pass Level = 26.00
Battery Test - Standby
Loaded Battery 7.84
Low Battery = 7.00