User's Manual

This message shows the battery voltage for the unit connected to the probe while
the Test Box loads that battery. The Low Battery for the Unit is also displayed.
The Test Box will automatically step to the next message.
This message will be displayed until the
probe is removed from the Unit being
tested.
Controller Messages
Connect the Test Box probe to the Controller Unit antenna connector. Hold
down the ‘3’ button on the Controller Unit while pressing the ‘ON’ button. This
puts the Controller in the Program/Test mode. When the Test Box detects that a
Controller is connected to the probe, the following message will be displayed.
The data displayed will be the actual configuration data from the unit connected
to the probe.
The Test Box will automatically step to the next message.
Loaded Battery 7.84
Low Battery = 7.00
Testing Completed
Address 65324 Unit 0
Frequency 154.570 Mhz