User's Manual

1673 OPERATION MANUAL REV A
40
selections are shown in Table 5-3. You can scroll through the various menu options with the up
and down arrow keys and press the number to make the selection. Press the back arrow or MENU
switch to escape. Follow the on screen instructions.
Item
Item Name
Description
1
DISPLAY GPS
Displays the GPS coordinates along with GPS date and time.
2
MOTION DETECT BG
Calibrates the Motion Detection feature of the 1673.
3
SET TIME ZONE
This should be set to the correct GMT for your local area.
4
SET LCD CONTRAST
Change the contrast for the LCD test. Higher number means darker text.
5
BATT DSHCH TIME
Displays the last battery discharge time when discharge-mode was used. Can be useful for determining battery health.
6
FIRMWARE VER.
This displays the current version of firmware and the program checksum for the main processor.
Table 5-3 Remote Unit Normal Menu Options
5.5. REMOTE UNIT ADVANCED USER
5.5.1. The Advanced User menu allows the user to make changes to system settings that are
not normally required for the day to day operations of the RFD. The Advanced User menu requires
a 4-digit PIN code for access to prevent unauthorized changes to the system settings. The PIN
code must be obtained from the Manufacturer or from the Distributor where you purchased the
RFD. We recommend that you keep your PIN code confidential and share only with personnel with
a need to make changes and understand the impact of those changes on the system as a whole.
Item
Item Name
Description
1
CONFIGURE MODE
Allows changes to the various features:
ASM: Auto-Select Mode (Enabled – 1) allows auto selection of responding Remote Units.
RLM: Receive Light Mode (Carrier Detect – 1) RX lights whenever signal present, (RX Data – 0) lights only when receiving messages
CM: (Default – 1) requires 2-way communication for Arm and Fire.
GPS: Used to enabled GPS on GPS equipped units.
2
WIFI
Not currently Available
3
USB
Allows a serial connection to a PC for downloading history log, changing settings, and changing configuration data.
4
LED INTENSITY
You can change the brightness of the LED displays between dim, medium, and bright (default is medium). The unit remembers the last used setting.
5
TESTS
Tests can be performed of the LED display and GPS signal data (current position, date and time) can be viewed.
6
SET RTC
For units without GPS, a real-time-clock (RTC) is available for logging history events. You can change the settings here.
7
DISP RCOUNT
Display rolling count stored in key and fire count.
8
SET SEQ TIME
If you are using sequential firing mode, there will be a delay between the firing of each Remote unit. You can change the delay here in millisecond
increments. When firing multiple Remote Units, this can help to prevent Motion from one blast event from being picked up by another blast event.
9
DISP KEY DATA
Displays configuration information stored in the Electronic Key..
Table 5-4 Remote Advanced User Menu