User's Manual

1673 OPERATION MANUAL REV A

REGULATORY INFORMATION

UNITED STATES

This device complies with Part 15 of the FCC regulations. Operation is subject to the

following two conditions: (1) That this device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

The radio contained in this device operates in FCC regulated frequency bands. This

device must be licensed by the FCC before use. Because this device contains a

transmitter, federal law prohibits unauthorized use or adjustments of this radio.

Note: The Grantee is not responsible for any changes or modifications not expressly

approved by the party responsible for compliance. Such modifications could void the

user’s authority to operate the equipment.

CANADA

**This Class B digital apparatus meets all requirements of the Canadian Interference-

Causing Equipment Regulations.

Cet appareil nume’rique de la classe B respecte toutes les exigences du Re’glement sur

le mate’riel brouilleur du Canada.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation

is subject to the following two conditions: (1) this device may not cause interference,

and (2) this device must accept any interference, including interference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables

aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions

suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de 'appareil

doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible

d'en compromettre le fonctionnement

Under Industry Canada regulations, this radio transmitter may only operate using an

antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry

Canada. To reduce potential radio interference to other users, the antenna type and its

gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not

more than that necessary for successful communication.

These radio transmitters (IC: 2758A-167301 & 2758A-167302) have been approved by

Industry Canada to operate with the antenna types listed below with the maximum

permissible gain and required antenna impedance for each antenna type indicated.