User Manual
EN
User Manual
17
LIMITED DISTANCE RANGE:
• Reposition the units.
• Increase the distance from walls and ceilings.
• ELSP Mode: In speed sync mode the distance
range is reduced by approximately 50 %,
switch back to normal sync mode.
• Outdoors, the distance range could be reduced
due to humidity, interference, obstacles etc.
INTERFERENCE WITH OTHER 2.4 GHZ
NETWORKS, UNRELIABLE TRIGGERING:
• Try another frequency channel for both
transmitter and the receiver of the EL-unit.
• Reduce the distance between the flash unit and
transmitter.
HS MODE; SYNC UP TO 1/8000S:
• Elinchrom Action (previously A) heads are not
optimised for the HS mode. To benefit from
better performance please use flash units with
Pro flashtubes (Standard or S previously) or
ideally use with dedicated HS heads.
• ODS fine tuning helps to optimise HS
performance.
• If there is visible banding please reduce the
shutter speed on your camera, or set ODS and
adjust to minimise or avoid banding.
• HS functionality only works with Canon or Nikon
cameras and the appropriate transmitter.
SCANNING EL-UNITS:
NO EL-UNIT FOUND, OR SOME UNITS ARE
MISSING.
• Switch on all enabled EL-units, than switch on
the EL-Skyport Transmitter Plus HS on or go to
setup and rescan.
• Frequency, group and ELSP mode settings
must match with the transmitter.
• Ensure that all EL-Skyport Transmitter Plus
HS enabled units are operating on the latest
firmware.