Owner's manual

ManualsBrandsRough Country ManualsCar1010

09-UP FORD F150 WINCH PLATE

THANK YOU FOR CHOOSING ROUGH COUNTRY FOR YOUR OFF ROAD NEEDS.

Rough Country recommends a certified technician install this kit. In addition to these instructions, professional knowl-

edge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install this

kit without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have

all needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.

Does not fit the eco-boost models

PRODUCT USE INFORMATION

Install winch with instructions supplied with winch. Always practice safe winching and recovery. Never overload a winch

or use the winch which in any way would void your manufactures warranty.

92101000

10mm wrench /socket

15mm wrench /socket

16mm wrench /socket

3/8” Wrench

3/4” Wrench

Reciprocating Saw

Body Sway

Tools Needed:

1010 Box Contains:

Winch Plate

Fairlead Bracket

Control Box Bracket

2-Flag Nuts

1010 Poly Bag:

2-1/2” x 1.5” Bolts

2-1/2” Flat Washers

2-3/8” X 1 1/4 Bolts

2-3/8” Lock Nuts

2-6mm x 16mm Bolts

2-16mm Lock Nuts

2-1/4” x 3/4” Bolts

2-1/4” Lock Nuts

Kit Contents:

Summary of content (4 pages)

PAGE 1
92101000 09-UP FORD F150 WINCH PLATE THANK YOU FOR CHOOSING ROUGH COUNTRY FOR YOUR OFF ROAD NEEDS. Rough Country recommends a certified technician install this kit. In addition to these instructions, professional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install this kit without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle. Please read instructions before beginning installation.
PAGE 2
1. Remove the tow hooks using a 15mm socket. Retain the hardware for reuse. See Photo 1. 2. Remove the rubber lower shield by removing the push in retainers from inside the bumper. See Photo 2. PHOTO 1 REMOVE TOW HOOKS PHOTO 2 REMOVE THE LOWER RUBBER SHIELD 3. Place winch plate in place and hold in place with the tow hook bolts. See Photo 3. 4. Trim the plastic as needed to install the plate. See Photo 4. PHOTO 3 PLACE WINCH PLATE ON MOUNTS PHOTO 4 TRIM PLASTIC AS NEEDED 5.
PAGE 3
7. Install the winch in the winch plate with the hardware included with the winch. See Photo 7. 8. Remove the plugs from the box and remove the top of the box. See Photo 8. PHOTO 7 INSTALL WINCH ON PLATE PHOTO 8 REMOVE TOP COVER TO ACCESS BOLTS 9. Remove the mounts from the box using a 3/8” wrench. See Photo 9. 10. Install the supplied 6mm x 15mm bolts in the box and secure the bracket to the box with the supplied 6mm nuts as shown. Tighten using a 10mm wrench. See Photo 10.
PAGE 4
13. Remove the plastic retainers as shown in Photo 13. 14. Reverse the plastic retainers and reinstall in rubber as shown in Photo 14. 15. Reinstall the rubber shield.