User guide

TJ ROCK GUARDS
Thank you for choosing Rough Country
Please read instructions before beginning installation. Check the kit hardware against the Kit Contents list and product
layout. Be sure you have all needed parts and know where they go. Also please review tools needed list and make sure
you have needed tools.
If questions exist we will be happy to answer any questions concerning the design, function, and correct use of this prod-
uct. Rough Country phone number 1-800-222-7023
INSTALLATION INSTRUCTIONS
1. Remove rock guards from box, lay them out on the floor to distinguish driver side from passengers side. Driver side
will be stamped with part # 94001033. Passenger side will be stamped part # 94001034.
2. Place rock guard where the front of the guard is in front of the body mount as shown, and the rear is behind the body
mount. See Figure 1 & 2. Clamp the front and rear mounting plate in place.
Kit Contents
1– Drivers Side Rock Guard
1– Pass Side Rock Guard
1– Kit Bag
16– 3/8” x1” Self Thread Bolts
Tools Needed
Drill
5/16” Drill Bit
14mm Socket
Center Punch
92103400
Figure 2
Passenger Front Passenger Rear
PASSENGER SIDE INSTALLATION SHOWN
3. When rock guards are in the desired location and are level, mark holes to be drilled using a center punch. See Fig-
ure 3. Unclamp the rock guards from the frame rail and remove the rock guards.
4. Using a 5/16” drill bit drill the 8 holes in the frame rail, making sure to keep the drill level when drilling the holes. See
Figure 4.
Figure 1