User guide

6. Carefully remove the bumper / grill from vehicle. See Photo 7.
7. Remove the sway bar from the frame with a 18mm socket. See Photo 8.
8. Allow the sway bar to hang.
9. The 4 holes marked will need to be drilled using a 9/16” drill bit. See Photo 9.
10. Mark the frame as shown, measuring across 3 1/2” and 1” up from the bottom of the opening. See Photo 10.
11. Trim the corner and slot the frame using a reciprocating saw as shown in Photo 11 to allow the winch frame bracket
to be installed. Paint area to prevent rust.
12. Slide the supplied plate between the bottom of the frame and the sway bar, line up holes in frame and secure with
the stock sway bar hardware. See Photo 12. Tighten using a 18mm socket.
Photo 7
Photo 8
Photo 9 Photo 10
Photo 11 Photo 12
REMOVE THE BUMPER FROM THE GRILL REMOVE THE SWAY BAR FROM THE FRAME
ENLARGE THE HOLES MARK FRAME TO BE CUT
FRAME SHOWN TRIMMED PLACE SUPPORT BRACKET ON FRAME