Manual

WJ JEEP ADJ FR TRACK ROD FOR 2”-6” LIFT

Thank you for choosing Rough Country for all your suspension needs.

Rough Country recommends a certified technician install this system. In addition to these instructions, professional

knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install

this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.

Please read instructions before beginning installation. Check the kit hardware against the kit content list. Be sure you

have all needed parts and know where they go. Also please review tools needed list and make sure you have the nec-

essary tools to install this kit.

PRODUCT USE INFORMATION

Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the

Rough Country product purchased. Mixing component brands is not recommended.

92108400

Tools Needed:

15mm Socket / Wrench

18mm Socket / Wrench

19mm Socket / Wrench

Torque Specs:

Size Grade 5 Grade 8

7/16” 45 ft/lbs 60 ft/lbs

Class 8.8 Class 10.9

12MM 55ft/lbs 75ft/lbs

Kit Contents:

Track Rod Body

Heim End

Poly Bag Containing:

Heim End Spacers (2)

Bushings (2)

Sleeve

12mm x 65mm Bolt

Flat Washer

12mm Lock nut

Jam Nut

PAGE 1
92108400 WJ JEEP ADJ FR TRACK ROD FOR 2”-6” LIFT Thank you for choosing Rough Country for all your suspension needs. Rough Country recommends a certified technician install this system. In addition to these instructions, professional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
PAGE 2
INSTALLATION INSTRUCTIONS 1. Place the vehicle on a level surface and chock the rear wheels. 2. Remove the track bar using a 19mm wrench/socket from the driver side mount. See Photo 1. 3. Remove the track bar from the axle using a 15mm wrench as shown in Photo 2. Retain the axle hardware for reuse. Photo 1 Photo 2 4. Lubricate the supplied bushings / sleeves with a lithium grease and assemble the bushings and sleeves in the track bar end. 5.