Owner manual

POST INSTALLATION INSTRUCTIONS
1. Check all fasteners for proper torque. Check to ensure for adequate clearance between all rotating, mobile, fixed, and
heated members. Verify clearance between exhaust and brake lines, fuel lines, fuel tank, floor boards and wiring har-
ness. Check steering gear for clearance. Test and inspect brake system.
2. Perform steering sweep to ensure front brake hoses have adequate slack and do not contact any rotating, mobile or
heated members. Inspect rear brake hoses at full extension for adequate slack. Failure to perform hose check/ replace-
ment may result in component failure.
3. On some vehicles the front lower skirting will need to be trimmed if using certain wheel /tire combinations and with
heavy offset wheels. Trim only as needed.
4. Activate four wheel drive system and check front hubs for engagement.
5. Have a qualified alignment center align the vehicle immediately. Realign to factory specifications. The following are the
recommended specifications:
Caster in degrees 4.5 +-1.0
Camber in degrees 0.0—.3
Toe In in degrees 0.1 +-.2
Important note: For alignment purposes, please refer to the instructions above. The inner & outer tie rod ends may
need to be trimmed to allow the front end alignment to be set properly. Please alert your alignment specialist of
this possibility.
6. Perform head light check and adjustment to proper settings.
7. Check and retighten wheels at 50 miles and again at 500 miles.
8. All kit components must be retightened at 500 miles and then every three thousand miles after installation. Periodically
check all hardware for tightness.
9. Install “Warning to Driver” decal on sun visor
Note: Installation of larger tires will require speedometer recalibration.
Thank you for choosing Rough Country for all of your suspension needs.
INSTRUCTIONS FOR TRIMMING TIE ROD ENDS.
1. Disassemble the tie rod from the tie rod ends
2. Measure over 3/8” and mark.
3. Cut the tie rods / tie rod sleeves as shown below to allow the vehicle to be realigned.
4. Smooth any rough edges.
5. Reassemble the cut assembly