Product Manual

Page 1 of 7
Thank you very much for choosing a Roughneck™ Product! For future reference, please complete the owner’s
record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to become
familiar with this product before you begin using it.
This machine is designed for certain applications only. The distributor cannot be responsible for issues arising
from modification. We strongly recommend this machine is not modified and/or used for any application other
than that for which it was designed. If you have any questions relative to a particular application, DO NOT use
the machine until you have first contacted distributor to determine if it can or should be performed on the
product.
For technical questions, please call 1-800-222-5381.
INTRODUCTION
The fuel transfer pump kit is a positive displacement, rotary vane pump with built-in bypass valve. Depending
on installation and viscosity, the pump can deliver up to 20 GPM. Its rugged design makes for a long life of
dependability. Kit includes pump, turbine digital meter, manual dispensing nozzle, 13ft. delivery hose, steel
suction pipe and 2in. tank adapter.
TECHNICAL SPECIFICATIONS
Electrical Power
Flow Rate
Model
Current
Voltage
GPM/LPM
Inlet/ Outlet
Nozzles
22648
DC
12
20/76
1in.
Manual
GENERAL SAFETY REGULATIONS
WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to
follow the safety rules and other basic safety precautions may result in serious personal injury.
Save these instructions in a safe place and on hand so that they can be read when required. Keep
these instructions to assist in future servicing.
WARNING: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions or situations that could occur. It must be understood by the
operator that common sense and caution are factors that cannot be built into this product, but must be supplied
by the operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in injury.
2. Keep children away from work area. Do not allow children to handle this product.
3. Store idle equipment. When not in use, tools and equipment should be stored in a dry location to
inhibit rust. Always lock up tools and equipment, and keep out of reach of children.
4. Use the right tool for the job. Do not attempt to force small equipment to do the work of larger
industrial equipment. There are certain applications for which this equipment was designed. It will do the
job better and more safely at the capacity for which it was intended. Do not modify this equipment, and do
not use this equipment for a purpose for which it was not intended.