Product Manual

Page 2 of 7
5. Check for damaged parts. Before using this product, carefully check that it will operate properly and
perform its intended function. Check for damaged parts and any other conditions that may affect the
operation of this product. Replace damaged or worn parts immediately.
6. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury,
etc.
7. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating this equipment may result in serious personal injury.
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
To ensure safe and efficient operation, it is essential to read and follow each of these warnings and
precautions.
WARNING: Improper use or installation of this product can cause serious bodily injury or death.
NOT FOR USE WITH LIQUIDS SUCH AS GASOLINE, ALCOHOL, EXPLOSIVES, CORROSIVES AND
FLAMMABLE, ALIMENTARY LIQUIDS.
Do not use the unit in an explosive environment.
Do not use the unit next to flammable liquids (gasoline, alcohol, etc.).
Do not use the unit in closed environments in the presence of gasoline, LPG or methane fueled vehicles.
Do not smoke near pump or use pump near an open flame. Fire could result.
Disconnect power to pump before servicing pump.
Turn off the switch before connecting power.
Take motors needing service to an authorized repair shop or return to factory to maintain.
A filter should be used on pump outlet to ensure that no foreign material is transferred to fuel tank.
Tank or barrel should be anchored to prevent tipping.
Always wear fuel-resistant gloves and clothes during diesel delivery and wash hands with water and soap at
the end. Clean fuel spills at once to avoid slips and/or pollution.
Always wear suitable clothes and use suitable protective devices when cleaning, especially when removing
dust or waste. Always use aspirators when cleaning fuel spills.
Never place hands or limbs under moving parts.
WARNING：
1. Electrical wiring should be done a licensed electrician in compliance with local codes. Rigid conduit should
be used and proper ground must be provided to avoid the possibility of electrical shock. Failure to comply
with this warning could result in serious injury and/or loss of property.
2. This product should not be used for fluid transfer into aircraft. This product is not suited for use with fluids
for human consumption or fluids containing water.
3. Extreme operating conditions with working cycles longer than 30 minutes can cause the motor
temperature to rise, thus damaging the motor itself. Each 30-minute working cycle should always be
followed by a 30-minute power-off cooling phase.
4. MAXIMUM BYPASSING TIME: 2 MINUTES.
5. DO NOT RUN DRY OVER 30 SECONDS.