20 GPM HD FUEL TRANSFER PUMP WITH TURBINE DIGITAL METER OWNER’S MANUAL WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury.
Thank you very much for choosing a Roughneck™ Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This machine is designed for certain applications only. The distributor cannot be responsible for issues arising from modification.
5. Check for damaged parts. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of this product. Replace damaged or worn parts immediately. 6. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etc. 7. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
OPERATING CONDITIONS 1. ENVIRONMENTAL CONDITIONS Temperature: Min -4°F (-20°C)/ Max +140°F (+60°C) Relative Humidity: Max 90% 2. FLUID COMPATIBILITY These products are compatible with the following fluids: Diesel, Kerosene and/or Mineral Spirits. DO NOT use with other fluids. INSTALLATION 1. Tightly screw suction pipe into inlet coupling of pumping unit. Extend suction pipe into truck tank or barrel. Make sure that there is at least 3in. away from tank bottom. 2. Screw inlet coupling of pump into 2in.
1 Wait for the meter to go to standby. 2 Reset the resettable total. 3 Start dispensing into a measuring glass. Stop dispensing when over 5 liters of volume is reached, then read out the actual value. The volume that is displayed on the LCD is the Display Value, not the Actual Value, which may be slightly higher. For example, in the figure on the right, the Display Value is 18.96 while the Actual Value is 20.75. 4 Press the MENU key. Keep it pressed until showed as the right fig.
a distance of 3 feet from the electric pump. MECHANICAL RISKS Mechanical parts subject to wear and tear Parts such as blades, bearings, rotors, etc. should be replaced with original spare parts by qualified personal only or in authorized service centers. Risks due to extreme temperatures Make sure the pump works at the ambient temperature ranging from -4°F (-20°C) to 113°F (45°C). Remember that operating at a very low temperature (about -4°F/ -20°C) can freeze the oil inside the pump.
DIAGRAM & PARTS LIST No. Description Quantity No.
WARRANTY One-year limited warranty Distributed by Northern Tool + Equipment Co., Inc. Burnsville, MN 55306 NorthernTool.
