Product Manual

Page of 7

3 Slide front leg assembly (part no.14)

into tray support, aligning holes in tool tray

(part no.3) with holes in front leg assembly.

Slide tray pin (part no. 11) through the

holes and fix with clip (part no. 12). As

shown in Fig 2.

4 Place base assembly (part no.1) upside

down on ground as shown in Fig 3 and

place legs into the holes with front leg

assembly (part no.14) toward jaws. Insert

leg bolts (part no.6), secure with nuts and

lock washers (part no. 7)

5 Turn the stand right side up and straighten

tool tray. Adjust and tighten the set screw

(part no. 13) at desired height. As shown in

Fig 4.

6 After finishing the assembly, place pipe into vise. Tighten the vise to hold the pipe in

place. Do not drop the pipe on the vise or use handle extensions when tightening the

vise, as this can damage the vise. Make sure the pipe and stand are stable for the

work to be done. For best stability during use, keep the pipe end as close to the vise

as possible. Use appropriate pipe supports if the pipe extends past the base of the

stand. Failure to properly support the pipe can cause chain breakage, vise tipping,

falling pipe and serious injury.

When using the vise, do not over reach and maintain proper footing and balance at all

times. This allows better control in unexpected situations.

Fig 2

Fig 3

Fig 4

Fig 3