Product Manual

Page 11 of 17
electrical shock, use extra care when connecting the pump to power.
 Avoid prolonged skin contact with petroleum fuels. Use protective goggles, gloves and aprons in
case of splashing or spills. Change saturated clothing and wash skin promptly with soap and
water.
 Wear the proper protective gear including ANSI Z87.1 compliant safety goggles while operating.
 This product should not be used for fluid transfer into an aircraft. This product is not suited for use
with fluids for human consumption or fluids containing water.
 Extreme operating conditions with working cycles longer than 30 minutes can cause the motor
temperature to rise, thus damaging the motor itself. Each 30-minute working cycle should always
be followed by a 30-minute power-off cooling phase.
 Use PTFE tape on all pipe threads.
 Do not exceed the maximum by-passing time of 3 minutes.
 Do not run dry past 30 seconds.
 Burn hazard. To reduce the risk of burns, do not touch hot surfaces.
OPERATING CONDITIONS
Temperature: Min. -68°F Max.104°F (Min. -20°C / max +40°C)
Relative Humidity: max 90%
FLUID COMPATIBILITY
These products are compatible with the following fluids:
Gasoline, Diesel, Kerosene, and Mineral Spirits
⚠CAUTION
Do NOT use with other fluids without consulting manufacturer.
 If using flexible tubing, attach the ends of the tubing to the tanks. In the absence of an
appropriate slot, solidly grasp the delivery tube before beginning dispensing.
 Before starting the pump make sure that the delivery valve is closed (dispensing nozzle or line
valve).
 Turn the ON/OFF switch to ON. The by-pass valve allows functioning with the delivery closed for
only brief periods.
 Open the delivery valve, solidly grasping the end of the tubing.
 Close the delivery valve to stop dispensing.
 When dispensing is finished, turn off the pump.
After Each Use
⚠WARNING