Specifications

1
VERTICALS
20
No. 12 x 1/2”
Sheet Metal
Screw
If fencing or decking is
to be installed, refer to
the deck and fence instructions before
installing the verticals.
The holes indented in the face of the
verticals must be on top.
If your pool is equipped with feature
tape, it is best to apply it to the verticals
at this time.
VERTICAL
VERTICALS OVER SUPPORT POSTS
Only install 2 screws at the bottom
of the verticals that go over the
support posts. Make sure you
use the two holes on the outside,
closest to the pool wall.
On top you must install all 4 screws.
On all the other verticals you must
install the 4 screws on top and at the bottom.
VERTICAL
OVER
SUPPORT
POST
Attention:
If your pool has the 2 piece
resin vertical, insert the
flat piece into the verticals
for the round side of the
pool. The verticals over
the Support Posts on the
straight side of the pool do
not need this sheet.
INSTALLATION OF VERTICALS USING THE "SNAP IN" RESIN BOTTOM PLATE
Press down firmly until the tabs in the plate snap
into the holes in the vertical and lock in place.
"Snap In"
Resin Plate
2
TO DISASSEMBLE
To remove the
vertical from the
plate simply use
a flat head screw driver
and pry the vertical in
and up from the plate
23