Installation manual
No Diving or Jumping. Observe all Safety Rules
1-5
3. Make the are at and level
a. Replace the centre peg with a at-topped stake, at least
1” (25mm) square and 6” (15cm) long. Drive it down
ush with the ground surface.
b. Nail one end of a straight 2-by-4 (5cm x 10cm) wood
plank to the top of the stake. Use a nail long enough to
hold the end of the 2-by-4 (5cm x 10cm) wood plank to
the stake while you rotate it in a circle. (Image 4)
c. Put a carpenter’s level on the wood plank and swing the
board in a circle to nd the high and low spots. (Image 5)
d. Remove all the high spots with a shovel, hoe or rake.
(Image 6)
B. CONT. PREPARE THE FOUNDATION OF YOUR POOL
GENERAL INSTRUCTIONS - ROUND POOLS
GROUND PREPARATION
Secon
1
4
5
6
Important Note:
Use the optical level to ensure that the ground is perfectly at
and level.