Installation manual

No Diving or Jumping. Observe all Safety Rules

1-8

4. Patio Stones (Optional)

a. Concrete patio stones may be placed at the base of each

upright of your pool.

b. Each bottom plate will show the location for a patio

stone. Make a mark in the ground at each base plate.

(Image 12)

c. Remove the bottom rails and bottom plates and lay out

the patio stones around the circle where the bottom

plates were. (Image 13)

d. The patio stones must be sunk into the ground so

the tops are ush with the soil around them. Use the

carpenter’s level to make sure the patio stones are

perfectly level and ush with the ground. Use either the

carpenter’s level and a 2-by-4 (5cm x 10cm) wood plank,

or the optical level between patio stones to make sure

the stones are level with each other. (Image 14)

e. Do not install blocks or rails on loose sifted soil or sand.

There must be no space between the ground and the

bottom of the rails. All patio blocks must be ush

with the ground, solid and level with each other in all

directions.

NOTE: Installing patio blocks is optional and the blocks

may shift due to temperature changes.

5. Proceed to Section 2 -

Assembling the Pool Base

B. CONT. PREPARE THE FOUNDATION OF YOUR POOL

GENERAL INSTRUCTIONS - ROUND POOLS

GROUND PREPARATION

Secon

Important Note:

Make sure the patio stones are perfectly level and ush with

the ground. All patio blocks must be ush with the ground,

solid and level with each other in all directions.