Installation manual
3-1No Diving or Jumping. Observe all Safety Rules
1. Preparing for the wall installation
a. Bring the following items into the middle of the pool foun-
dation before you start uncoiling the pool wall: plywood,
some extra sand or ne dirt to make the cove and a lad-
der to climb out after the wall is assembled.
b. Make sure the skimmer and water return holes are
located where you need them to be. The skimmer and
water return holes are positioned towards the end of the
wall, (the section before where the wall started).
2. Set the pool wall in place
a. Unpackage the coiled pool wall and stand it on the ply-
wood at the place close to where you need to install the
skimmer. (Image 1)
(Remember the skimmer and water return holes will be
placed at the section just before where you started the
wall installation).
b. Start uncoiling the wall, guiding the bottom edge into
the curved bottom rail. The starting end of the wall must
be positioned in the centre of a bottom plate, and the
skimmer and return holes should be positioned where the
pump and lter will be.
(Image 2)
A. SETTING UP THE POOL WALL
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
Secon
3
Do not attempt to install the pool wall in the wind, wait for a calm day.
It takes at least 3 people to install the pool wall.
1
2
Important Note:
It is preferable to use very ne sand that is easily compacted.
Be careful not to spill sand on the bottom rails.