Installation manual

3-4 No Diving or Jumping. Observe all Safety Rules

A. CONT. SETTING UP THE POOL WALL

GENERAL INSTRUCTIONS - ROUND POOLS

ASSEMBLING THE POOL WALL

Secon

c. To fasten the wall joint, overlap the two steel bars, one

on the inside and the other on the outside. Tighten the

mechanical screws on the inside and the nuts on the

outside. Ensure that all botls and all the holes are used.

(Image 8)

d. Adjusting the pool to the proper shape may cause the

bottom rails and bottom plates to slip out of alignment a

little. Recheck all of the bottom plates to make sure each

one is centred where the bottom rails meet.

e. Cover the seam and bolt heads on the inside/interior of

the pool wall completely with 2” (50mm) duct tape. (Im-

age 9)

4. Make sure the pool wall is round

a. Using a tape measure, measure across the circle at each

bottom plate. The pool wall must be round. Adjust the

circle by nudging the base plates in or out with your foot.

(Image 10)

Important Note:

Stick a screwdriver through two of the holes to help line up the

ends of the wall.

When tightening the screws start from either the top

and go down or vice versa. Do not start a few screws

from top and a few from the bottom to meet in the

middle, this can cause problems later on.

Important Note:

The pool must be level across the perimeter. A pool that is not

level is dangerous and may collapse.