Installation manual

3-8 No Diving or Jumping. Observe all Safety Rules

C. CONT. INSTALL THE POOL LINER

Secon

GENERAL INSTRUCTIONS - ROUND POOLS

ASSEMBLING THE POOL WALL

Please ensure to follow instrucons that match the type of liner you may have.

2. Fasten the liner place

2-1. For OVERLAP ONLY

(Please see step 2-2. or 2-3. for other liner)

a. Starting at the liner wall seam, hang the liner over the

wall making sure that the seam is straight up and down,

perpendicular to the oor. (Remove stabilizers gradually

as you fold the liner over the top of the wall. )This will as-

sure you that the liner begins going over the wall straight.

(Image 18)

b. As you put the liner over the wall you can secure it by

using the plastic coping strips to keep it in place. If you

end up with excess material, continue around the pool,

pulling excess liner evenly, and distribute over the wall

until the excess is gone. (Image 19)

c. Fasten the liner to the top of the wall with plastic coping.

Let the liner hang slack for now. Do not pull the liner tight.

(Image 19)

NOTE: Some liners may t very tightly, it is better to install

uprights, top plate and rail before going onto next step.

See Section 4.

d. Turn the vacuum cleaner on and push the liner outward

with your feet to iron out any wrinkles. Once nished, turn

off vacuum cleaner.

e. Start lling the pool with water. As the pool lls, work out

all the wrinkles and smooth the liner to the wall. Remove

the plastic coping around the top edge of the wall one

piece at a time and adjust the liner. Keep smoothing out

the wrinkles.

Important Note:

Do not trim off the excess liner. (If the liner ever needs to

be removed, trimming the liner will make re-installation very

difcult). Instead, roll up any excess liner and tape it in place

near the top of the pool wall.

Plastic Coping

Liner OverlapOutside Pool

Wall