Installation manual
3-10 No Diving or Jumping. Observe all Safety Rules
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL WALL
Secon
3
C. CONT. INSTALL THE POOL LINER
2-2. For HUNG/J or V-BEAD LINER ONLY
(Please see step 2-1. or 2-3. for other liner)
a. With a V-Bead liner you will not use the plastic coping
strips that are packed in the parts carton of your pool.
You can discard those pieces, if they are included, as
they only apply to pools with overlap liners.
b. The top of the wall of the liner has what is called a “V-
Bead” welded onto it. Simply open up the bead with
your ngers and hang it directly on top of the pool wall.
When this is done properly, the only portion on the out-
side of the pool wall is approximately 1” of the V-Bead.
No printed liner material is actually going over the top of
the wall to the outside of the wall. (Image 22)
c. Make sure the bead is on evenly around the entire pool,
and that the liner is hanging straight down from the top of
the wall. The liner should not have creases in it because
it is twisting around the pool. If the liner is twisting, it is
because it is not sitting properly in the pool. Make nec-
essary adjustments before proceeding.
NOTE: Some liners may t very tightly, it is better to install
uprights, top plate and rail before going onto next step.
See Section 4.
3. Proceed to Section 4 -
Installing the Pool Frame
23
Important Note:
Do not trim off the excess liner. (If the liner ever needs to
be removed, trimming the liner will make re-installation very
difcult). Instead, roll up any excess liner and tape it in place
near the top of the pool wall.