Installation manual

3-11No Diving or Jumping. Observe all Safety Rules

GENERAL INSTRUCTIONS - ROUND POOLS

ASSEMBLING THE POOL WALL

Secon

C. CONT. INSTALL THE POOL LINER

2-3. For BEADLOCK/SNAPBEAD LINER ONLY

(Please see step 2-1. or 2-2. for other liner)

a. With a snap bead liner you will not use the plastic cop-

ing strips that are packed in the parts carton of many

pools. You can discard those pieces (if they are included).

Instead, you should have received a beaded liner track

(referred to as a “coping bead receiver” in Image 23).

b. The beaded liner track should be installed onto the pool

wall all of the way around the pool. These pieces should

be as close together as possible. Leaving spaces be-

tween bead tracks can cause liner problems later on.

c. Once all of the beaded liner track is on the wall, you can

snap the liner bead into the beaded liner track at four

random points around the pool. After that is done, and

you are satised with how the liner is situated within the

pool, you can continue snapping the remainder of the

liner into place around the pool.

d. Go around the entire pool again making certain that the

liner is securely snapped into the track. This is important

to conrm so that the liner does not pull out while under

the pressure of being lled with water.

NOTE: Some liners may t very tightly, it is better to install

uprights, top plate and rail before going onto next step.

See Section 4.

3. Proceed to Section 4 -

Installing the Pool Frame