Installation manual

No Diving or Jumping. Observe all Safety Rules

Secon

GENERAL INSTRUCTIONS - ROUND POOLS

ASSEMBLING THE POOL FRAME

1. Continue lling your Pool

a. Continuellingyourpoolwithwater.Donotputinmore

than12”(30cm)ofwateruntilthetopledgesandupright

columnsareallattached.

b. Keepworkingonthetopledgesanduprightswhilethe

poollls.

See the drawing on the next page for an overview of

all the parts used to install the uprights, top ledges

and top connectors.

2. Install the uprights.

a. Lineupthebottomofoneupright(key1)withthetwo

smalltabsononebaseplate(key2).Thetabsmustbe

ontheinsideoftheupright.Thethreeholesonthefront

oftheuprightmustbenearestthetop.

b. Lineupthescrewholesandfastenwithoneself-tapping

screwoneachside(key3). (Image 1)

c. Hookatopplate(key4)overthetopedgeofthepool

wall(key5).Placethetopplatedownover

thetopoftheuprightwiththetabson

theoutsideofthecolumn.Makesuretheuprightis

straightupanddown.

d. Lineupthescrewholesandfastenwithoneself-tapping

screwoneachsideandoneonthefront(key6).

e. Repeatthelastfourstepsforeachoftheuprightaround

thepoolwall.

A. INSTALLING THE TOP LEDGES AND UPRIGHTS

Important Note:

Use the ridges in the pool wall to make sure the upright is

straightupanddown.

4-1