Installation manual

No Diving or Jumping. Observe all Safety Rules

4-5

GENERAL INSTRUCTIONS - ROUND POOLS

ASSEMBLING THE POOL FRAME

Secon

d. Pushthelowerpartoftheconnectorintowardsthe

verticalcolumnandlineupthetwoscrewholesinthe

lowerportionoftheconnectorwiththetwoholesinthe

verticalcolumn.Fastentheconnectorinplacewithtwo

self-tappingscrews(Image 11). Important: Tightenthe

screwsonlyuntilasnugtisobtained.Donotover-

tighten.

e. InstalleitheraHook* (Key 10-Image 12)oraclip (Key

11-Image 13). Insertthelargecentertab&twosmallertabs

locatedatthetopofeachintotheopeningslocatedatthe

topofthecliphousingintheconnector.Rotatethebottom

oftheclip/hookintothehousingandpressrmlyatthe

bottomofthecliporhookuntilasnapisheard.Slightly

loosenthescrewsiftheclip/hookdoesnotsnapin.

*Note: your pool may not contain a Hook

f. InstalltheLogoandrepeatthelastsixstepsfortherest

oftheledgecovers.

B. CONT. INSTALLATION OF THE LEDGE COVERS

12 13