Installation manual

No Diving or Jumping. Observe all Safety Rules
GENERAL INSTRUCTIONS - ROUND POOLS
ASSEMBLING THE POOL FRAME
Secon
4
1. Finish lling the pool
a. Turnoffthevacuumandcarefullyremoveitfromthe
pool.
b. Fillthepoolwithwaterto2”(5cm)belowthelowest
opening.
c. Whilethepoolislling,removethenailsthatwere
holdingthebottomrailsinplaceandensurethattheyare
stillpositionedcorrectly.
d. Yourpoolisnowinstalled.Youmustnowinstallthelter
andpump,theskimmerandwaterreturninlet.Please
followtheinstallationinstructionsthatcomewiththese
products.
D. FILL YOUR POOL WITH WATER
Important Note:
Beforemakinganyopeningsintheliner,llthepoolwith60cm
(24”)ofwatertostretchthelinerfully.Whenllingyourpool,
begin with a garden hose until thereis about 30cm (12”) of
waterinthepool.Thiswillallowthelinertostretchgradually.
Youcanthenuseaheavierowtonishllingitup.
4-7
Important Note:
Makesurethatyourpool’sroundsectionsareround,donotassumethatbyllingupthepoolthatthiswillhelpthepool
toplaceitselfintoaperfectroundshape.Ensurethatitisroundbeforellingupthepoolwithwater.