User Guide

Page 6
Pressurizing
1. Make sure shut-o lock is not engaged. (If shut-o lock is engaged while pressurizing, the
unit will immediately start spraying).
2. Push down on the handle and turn counterclockwise to unlock the handle (See Figure G-1G).
3. Pressurize the sprayer by pumping the handle in a smooth up and down motion
(See Figure G-2G).
4. Push down on the handle and turn clockwise to lock the handle into the pump
(See Figure G-3G).
Figure G
1G 2G
3G
OPERATING INSTRUCTIONS
Filling
IMPORTANT: Always make sure the pressure
is released from the tank before lling or
servicing. Pull up on the knob of the pressure
release valve until all the pressure is released
from the tank. Then, and only then, it is safe
to remove pump.
1. Turn the pump handle counterclockwise to
remove the pump (See Figure E).
2. Fill the tank to the desired level. See ll
markings on side of tank. (Always refer to
chemical manufacturer for proper mixture).
3. Install the pump into the tank opening and
turn clockwise until tightly sealed against the
tank (See Figure F).
Figure FFigure E
ADDITIONAL USES CONTINUED
Seal Concrete: MAX VOLUME FAN NOZZLE (BROWN)
Apply curing compounds to freshly poured concrete.
Auto Detailing: HIGH VOLUME FAN NOZZLE (RED)
Clean tires & wheels, as well as degrease engines.
Foaming/Cleaning: HIGH PERFORMANCE FOAMING NOZZLE