- ROWE CD-100K LASERSTAR STARGLO FIELDSERVICEMANUAL & PARTS CATALOG VOLUME 1of 2 INSTALLATION,PROGRAMMING, ROUTINESERVICE

CD-100K Phonograph

2-16 21822666

Table 2-1 Extension Speaker Worksheet

Sheet 4 (Continued)

3. The phonograph wires to change are the Violet (channel 1) and the Pink (channel 2) on the output

transformer assembly (see Table 3-2A).

Use Table 3-2A as a guide to select the power used by the phonograph. This power should roughly match

the amount indicated in "Power Available for the Phonograph" on the previous page.

This value is the total for both channels. The power consumption for each channel is one-half of this value.

Phono Power

113

Phono Speaker Connections

Violet connects to Left E2, Pink Connects to Right E2

Violet connects to Left E3, Pink Connects to Right E3

Violet connects to Left E4, Pink Connects to Right E4

Violet connects to Left E5, Pink Connects to Right E5

Violet connects to Left E6, Pink Connects to Right E6

Violet connects to Left E7, Pink Connects to Right E7

Table 2-2A. Phonograph Speaker Power

Select the speaker taps that will use up most of the “Available Speaker Power”

You may select more or less phonograph power to suit your phonograph volume

preference.

Do not move the Black wire; it should stay on either the Left or Right E1 terminal.

Check that the amplifier is not overloaded by performing the following four steps:

1. Make sure that the extension speakers are connected to the proper speaker taps.

2. Set the volume control to maximum volume and make a selection.

3. While the music is playing, if the OVERLOAD INDICATOR(S) stay OFF or occasionally flicker

in a random manner, the load is acceptable. If the OVERLOAD INDICATOR(S) are always lit

or flicker continuously, the amplifier is overloaded and will shut down, and you must perform

Step 4.

4. Do this step only if the OVERLOAD INDICATOR(S) came on as described in Step 3. Find the

source of the overload (shorted speaker wires, too many speakers connected, or speaker

power taps too high). After you fix the short, disconnect a few speakers or lower the speaker

power tap selection, then repeat Step 3.

Table 2-2B. Amplifier Overload Check