User Manual

IMPORTANT SAFETY

INSTRUCTIONS

When using an iron, basic precautions should always be followed,

including the following:

READ ALL INSTRUCTIONS BEFORE USING

• Only use an iron for its intended use.

• To avoid the risk of electric shock, do not immerse the iron in water or

other liquids.

• Always turn the iron OFF before plugging or unplugging the iron from

the electrical outlet. Never pull on the cord to disconnect the iron from

the electrical outlet; instead, grasp the plug and pull on the plug to

disconnect the iron.

• Do not let the cord touch hot surfaces. Let the iron cool completely

before putting the iron away. Coil the cord loosely around the iron

when storing.

• The plug must be removed from the socket-outlet before the water

reservoir is filled with water.

• Do not operate the iron with a damaged cord or in the event the iron

has been dropped or damaged. To avoid the risk of electric shock,

do not disassemble the iron. Take it to a qualified serviceman for

examination and repair. Incorrect assembly might result in a risk of

electric shock when the iron is used after reassembly.

• Close supervision is required for any appliance used by or near

children. Do not leave the iron unattended while the iron is connected

or on an ironing board.

• Burns can occur from touching hot metal parts, hot water, or steam.

Use caution when you turn a STEAM IRON upside down – there might

be hot water in the reservoir.

• To avoid a circuit overload, do not operate an iron on the same circuit

with another high wattage appliance.

• If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualified person in order to avoid hazard.

• The iron must only be used with the stand provided.

• If an extension cord is absolutely necessary, a cord with an ampere

rating equal to or greater than the maximum rating of the iron shall

be used. A cord rated for less amperage can result in a risk of fire or

electric shock due to overheating. Care shall be taken to arrange the

cord so that it cannot be pulled or be tripped over.