Notice WaterControl 013982-N65 3/07/06 12:29 Page C1 D I F NL E P GB www.rowenta.
Notice WaterControl 013982-N65 3/07/06 12:29 Page C2 5 1 2 3 6 4 7 D I 8 F 9 NL E 10 P 11a GB GR 11b
Notice WaterControl 013982-N65 3/07/06 12:29 Page C3 • PREPARAZIONE • PRÉPARATION • VOORBEREIDING PREPARATION •• VORBEREITUNG PREPARACIÓN • PREPARAÇÃO • PREPARATION • ΠΡΟΕΤΟΙΜΑΣΙΑ 1L MAX A USE B C D • GEBRAUCH • UTILIZZO • UTILISATION • GEBRUIK • UTILIZACIÓN • UTILIZAÇÃO • USE • ΧΡΗΣΗ WAIT (8 min) OK E F G I J K H L 1L MAX M N O P • MANUTENZIONE • ENTRETIEN • ONDERHOUD MAINTENANCE •• INSTANDHALTUNG MANTENIMIENTO • MANUTENÇÃO • MAINTENANCE • ΣΥΝΤΗΡΗΣΗ C3 Q R S T
Notice WaterControl 013982-N65 3/07/06 12:30 Page 32 FOR YOUR SAFETY Please read these instructions carefully before first use. This product is for domestic use only. In any case of professional use, inappropriate use or failure to comply with the instructions, the brand accepts no responsibility and the guarantee does not apply. For your safety, this appliance conforms to the applicable standards and regulations (Low Voltage, Electromagnetic Compatibility, Environmental Directives, as applicable…).
Notice WaterControl 013982-N65 3/07/06 12:30 Page 33 DESCRIPTION 1. 2. 3. 4. 5. 6. 7. Handle of the iron Steam control button Thermostat to set the temperature of the soleplate Iron rest Steam cord Thermostat light Electric cord 8. Boiler cap 9. Boiler (inside the base-unit) 10. Water Control (water level indicator lights) 11. Control panel a. Illuminated on/off switch b.
Notice WaterControl 013982-N65 3/07/06 12:30 Page 34 USE 3 • Starting the generator Press the illuminated ON/OFF switch (E); it will switch on. The Water Control indicator lights will come on then progressively switch off (F) during the heating of the tank. When the steam is ready, the Water Control light will remain stationary and indicate the water level in the tank (G). During ironing, the light on the iron will go on and off according to heating requirements.
Notice WaterControl 013982-N65 3/07/06 12:30 7 • Filling the tank when it is empty during operation. VERY IMPORTANT : Before opening your boiler, ensure that there is no more steam left inside by pressing the steam control button located on the handle of the iron and keep it pressed down until there is no more steam. Stop the generator by pressing the on/off switch (N) and disconnecting the plug. Slowly unscrew the boiler cap.
Notice WaterControl 013982-N65 3/07/06 12:30 Page 36 IS THERE ANY PROBLEM? Problems Water runs through the holes in the soleplate. Possible causes The boiler is too full. The thermostat is not working : the temperature is always too low. You are using the steam control button before the iron is hot enough. Water has condensed in the pipes because you are using steam for the first time or you have not used it for some time. Solutions Do not fill the boiler right up to the top.