Operation Manual

3
EN
DESCRIPTION
Your iron has been designed to operate using untreated tap water. If in doubt, check with your
local water authority. However, if your water is very hard, you can mix 50% untreated tap water
with 50% distilled or demineralised water.
IMPORTANT Before doing anything else, remove the sticker on the side fig.1
Warning! Before using your iron with the steam function for the first time, we
recommend that you operate the steam in a horizontal position for a few moments,
away from your linen, i.e. press the Shot of Steam button a few times.
During the first few uses, a harmless odour and a small amount of smoke may be
noticeable.
This has no effect on the use of the iron and will cease quickly.
Upon the first use, you may notice small particles coming out of the soleplate. This
is parf of manufacturing process and is not harmful to you or your garments. It will
disappear after several uses. You may accelerate this by using the self cleaning
function (fig.13a - 13b) and shaking the iron gently.
BEFORE USE
1. LED screen
with Electronic Temperature Control
2. Shot of steam button
3. Steam ON / Steam OFF
4. Cord
5. Handle
6.
S
pray trigger
7. Thermostat control light
8. Water tank
9. Self clean button
10. Spray
11. High precision tip
12. Soleplate
13. Filling inlet
14. Temperature control dial
15. Rear Cover
WHAT WATER MAY BE USED ?
Small in size , Steamforce combines power and performance thanks to the compact steam
generator built inside the iron. With unparalleled steam generation capacity reaching
230g/min and variable steam of up to 65g/min, Steamforce pushes up to 50% more
steam* into the fibres of your fabric. This extra steam at the heart of the fabric is the
secret of perfect ironing and long-lasting results.
The movement sensor is an intelligent system which temporarily stops steam being
released when the iron is not moving, even when it is placed horizontally. This function
eliminates wasted steam while you are handling the clothes !
Throughout the ironing session, the LED screen displays the selected fabric type: as soon
as the appropriate temperature is reached, the user is informed directly via the screen.
This is ideal for protecting the most delicate garments.
* compared with an iron with no pump
STEAMFORCE, CONCENTRATED INNOVATION…
IMPORTANT Heat concentrates the elements contained in water during evaporation.
The types of water listed below contain organic waste or mineral elements that can
cause spitting, brown staining or premature wear of the appliance:
water from tumble dryers, scented or softened water, water from refrigerators,
batteries or air conditioners, pure distilled or demineralised water or rain water should
not be used in your iron. Also do not use boiling, or bottled mineral water.
1 • Filling the water tank
• Before filling the water tank, unplug the iron fig.2.
• Set the temperature control dial
fig.3 on position (Min.)
• Open the filling inlet
fig.4. Fill in water up to the Max. mark. fig.5. Close the filling
inlet and return the iron to the horizontal position.
• You can plug in your iron
fig.6
.
2 • Setting the temperature
Your iron is equipped with the Autosteam Electronic Control function, it
automatically adjusts the steam amount and the temperature based on the selected
fabric for optimum results. Select the fabric to be ironed by turning the thermostat
and checking the fabric to be ironed on the display
fig.7. For perfect results, an
optimum position for each fabric has been pre-defined. You can also set your iron
based on the international temperature measurements • •• •••.
When your iron reaches the required temperature, the selected fabric in the LED
screen stops flashing and is displayed constantly
fig.7. You can start ironing.
USE
1103910403 DW9240 F1_110x220mm 30/04/13 08:55 Page3