Not. DX1000 1103898336.
Not. DX1000 1103898336.qxd 30/01/06 14:41 Page 3 D Bitte lesen Sie diese Gebrauchsanweisung und die Sicherheitshinweise aufmerksam durch. Beachten Sie dabei die Abbildungen auf der ausklappbaren Bildseite. GB Please read carefully the instructions for use and the Safety Points to Note. Pay particular attention to the fold-out page with the illustrations. F Lire attentivement le mode d’emploi (et le conserver pour pouvoir le consulter). Pendant la lecture, déplier la page avec les illustrations.
Not. DX1000 1103898336.
Not. DX1000 1103898336.
Not. DX1000 1103898336.qxd 30/01/06 14:41 Page 11 English Dear customer, thank you for purchasing this appliance and for your confidence in us. Please read the operating instructions carefully and keep them in a safe place.
Not. DX1000 1103898336.qxd B 30/01/06 14:41 Page 12 Before use BEFORE DOING ANYTHING ELSE, REMOVE THE SOLEPLATE PROTECTOR AND DISCARD. Before using the iron for the first time: – Heat the appliance at the maximum setting without water (see D). A little smoke and a slight smell may be emitted, but this is only temporary. The water tank can then be filled directly with untreated tap water using a jug (see C). – Each time you begin ironing, allow the iron to emit steam for at least 1 minute.
Not. DX1000 1103898336.qxd 30/01/06 14:41 Page 13 Tip: We recommend that you start with fabrics to be ironed at a low temperature as the iron takes longer to cool down than to heat up. For mixed fabrics set the temperature for the most delicate fabrics. E Ironing and Steam functions E1 Dry ironing To iron without continuous steam, turn the steam control position and set the temperature to suit the (➌) to the type of material (care points •, •• or •••).
Not. DX1000 1103898336.qxd 30/01/06 14:41 Page 14 • After approx. 1 minute move the steam control slide to the position. • Insert mains plug and allow the iron to heat up again. • Wait until the remaining water has evaporated. • Unplug from the mains and allow iron to fully cool down. • When cool, the soleplate can be wiped with a damp cloth. We recommend using the Self Clean function approx. Every 2 weeks. If the water is very hard, the iron should be cleaned weekly.
Not. DX1000 1103898336.qxd I 30/01/06 14:41 Page 15 Problems? Problem Possible cause Solution The soleplate does not heat up or the thermostat light does not come on. No power supply. Thermostat light goes on and off. This is normal. When the thermostat light goes on and off, the iron is heating up. As soon as the light goes off, the choosen temperature has been reached. None or too little steam is being emitted. The steam control is set on position .
