User Manual

Before use
• Remove sole plate cover before using iron.
• Remove all packaging from the iron.
• Please read all ot the Instructions for Use and the
Important Safety Guards carrefully.
• It is normal for a small amount of smoke and a
light odor to be produced the first time it is used.
This will quickly disappear.
• Particles may emit from iron during first use.
They are not harmful and should disappear after
the iron has been allowed to steam.
Helpful Hints
• When ironing, start with fabrics that require a low temperature
setting (•) and finish with those which need the highest
temperature (•••).
• Mixed fiber fabrics should be ironed on the temperature for the
most delicate fabrics. For example a shirt that is 60 % cotton
and 40 % polyester should be ironed at the (•) setting for syn-
thetics.
• If spray starch is used, spray it onto the reverse side of the
garment. Allow starch to penetrate before ironing by setting
garment aside for 30 seconds.
• For best results, use a mesh type ironing board to allow excess
steam to escape.
• For delicate fabrics, we recommend carrying out a test on an
unobtrusive area of the garment such as an inner seam.
• Adhere to manufacturer recommendations on garment label.
3 Way Auto-Off (depending on model)
If your iron is equipped with auto-off and the iron is
not moved while it is plugged in, an internal safety
switch will turn it off.
It will turn off in 8 minutes if left vertically or in 30
seconds if left on its soleplate or tipped over.
The auto-off light will remain on and lit during iro-
ning.
The light will flash when the auto-off feature has
engaged.
To deactivate feature, move the iron or shake it gently.
Wait until iron is fully reheated before use.
Auto off is not an on/off switch. Always unplug the iron when
not in use.
4
30 sec. 8 min.
1103901474 DZ2060 Actisteam US 22/10/07 10:09 Page 4