User Manual

6
* depending on model
7 • Steam ironing
You can steam iron from temperature setting •• upwards.
Steam function* The steam level can be set to between no steam (minimum
steam quantity) and (maximum steam quantity) (fig.12). We recommend
setting to the maximum steam quantity only when the iron is at tempera-
ture setting •••.
Auto Steam function* Set the steam button to (fig.13) and
the steam quantity will adjust automatically to the soleplate temperature.
8 • Shot of steam
(from temperature setting •• upwards)
IMPORTANT Leave an interval of 4 seconds between each shot and wait until
the flow of steam is finished before standing the iron on its heel.
Press the shot of steam button to generate a powerful jet of steam and re-
move stubborn creases (fig.14).
9 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid bur-
ning delicate fabrics.
Hold the iron in a vertical position and press the shot of steam button
( fig.15) to remove creases from suits, jackets, skirts, hanging curtains etc.
IMPORTANT Never direct the steam at persons or animals!
10 • Spray
Press the spray button to dampen stubborn creases (fig.16).
11 • Anti-Drip system*
It prevents water from escaping out of the soleplate, when the temperature is
too low.
12 • Automatic electronic 3-position cut-out*
If the appliance is on but is not moved, it will automatically
switch off and the auto off light will blink after the following intervals (fig. 17):
- After 30 sec., if the iron is left standing on the soleplate or lying on its side .
- After 8 mins., if the iron is left standing on its heel.
To switch the iron back on, gentlymove the iron.
1103899517-index02 DZ5000_110x154 06/07/10 15:06 Page6