COUV_DZ9000_14Langues 22/02/06 11:42 Page 1 NL BG CZ SR HR RO SK TR S DK model DZ9030 PL SLO H www.rowenta.
COUV_DZ9000_14Langues 22/02/06 11:42 Page 2 6* 7 5 4 8 3a 3b 3c 3d 9* 3 10* 2 11b* 1 11c* 11a* 11d* 12 13 14
COUV_DZ9000_14Langues 22/02/06 11:42 Page 3 fig. 1 fig. 2 fig. 3 fig. 4 fig. 5 fig. 6 NO fig. 7 NO fig. 10 fig. 8 fig. 9 fig. 11 fig.
COUV_DZ9000_14Langues 22/02/06 11:42 Page 4 fig. 13 fig. 14 fig. 15 fig. 16 fig. 17 fig. 18 OK fig. 19 fig.
DZ9000-11038999469 2/03/06 14:29 Page 3 DESCRIPTION 1 2 3 4 5 6 7 Spray nozzle Filling inlet (with slide-button opening) Variable steam control a Dry ironing b Smooth steam c High Pressure steam d Self Clean Spray button Shot of steam button Auto-off indicator light* Cord 8 9 10 11 Handle Thermostat control light* Temperature control dial LED display* a Yellow LED b Green LED c Red LED d Auto-off LED 12 Water tank 13 Maximum water level indicator 14 Microsteam400 soleplate SAFETY INSTRUCTIONS This
DZ9000-11038999469 2/03/06 14:29 Page 4 – the appliance is obviously leaking. In these cases the appliance should be returned to an approved Rowenta Customer Service Centre for repair. (See enclosed Service Centre addresses.) Repairs to electrical appliances may only be carried out by specialists. Improperly carried out repairs can cause serious danger to users. To avoid danger to users, a defective or damaged supply cord may only be replaced by an authorised Rowenta Customers Service Centre .
s h DZ9000-11038999469 2/03/06 14:29 Page 5 contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the appliance: - water from clothes dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your iron. Also do not use boiled, filtered or bottled water. 3 • Using for the first time Plug in the iron (fig.
DZ9000-11038999469 2/03/06 14:29 Page 6 Temperature control*: The temperature control light indicates that the soleplate is heating up. When the temperature control light goes off (fig.9), the set temperature is reached and you can begin ironing. Fabric Temperature control Y q c W is Synthetic fibres, e.g. viscose, polyester… • 8 Silk, wool •• Cotton, linen ••• Ironing label Electronic temperature control*: The traffic lights tell you whether the soleplate is at the selected temperature (fig.
es g. DZ9000-11038999469 2/03/06 14:29 Page 7 7 • Steam ironing You can steam iron from temperature setting •• up. The steam quantity can be adjusted between Smooth Steam (soft steam continuous diffusion) up to High Pressure steam . We recommend setting to High Pressure steam only when the iron is at temperature setting •••. 8 • High Pressure Steam Your iron is fitted with the new High Pressure Steam system (fig.13).
DZ9000-11038999469 2/03/06 14:29 Page 8 13 • Automatic electronic 3-position shut off If, although switched on, the appliance is not moved, it will automatically switch off and the auto off light will blink after the following intervals (fig.17): - After 30 sec., if the iron is standing on the soleplate or lying on its side. - After 8 mins., if the iron is standing on its heel. C se p ir U W AFTER USE 14 • Emptying Unplug the iron (fig.4), pour away remaining water (fig.
DZ9000-11038999469 e. 2/03/06 14:29 Page 9 Clean position (fig.5) : steam will now begin to build up. After a few seconds water will merge from the soleplate, rinsing dirt and scale particles out of the steam chamber. Move the steam control to position after approx. 1 minute. Plug in the iron and allow the iron to heat up again. Wait until the remaining water has evaporated. Unplug from the mains and allow the iron to fully cool down. When cool, the soleplate can be wiped with a damp cloth.
DZ9000-11038999469 None or too little steam is being emitted. The soleplate is dirty or brown and can stain the linen. Iron is leaking. 2/03/06 14:29 Page 10 B Steam control set on dry position . Turn the steam control to the required setting area. Not enough water in the water tank. Anti-Drip* is active (§ 12). Fill the water tank. 1 2 Wait for the soleplate to reach the correct temperature. 3 Residues in the steam chamber or on the soleplate.
