RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page1 FR EN NL DE ES PT IT TR RU UK PU2120 INTENSE PURE AIR NC00113345/01 - 26/12
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page2 9 1 7 8 2 3 6 5 4
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page11 EN Read the instructions for use and safety instructions carefully before use and keep them. OPERATING PRINCIPLE • The ventilation system sucks air into the pre-filter, which removes the largest suspended impurities such as dust, pollen, pet hair, etc. • The air then passes into the activated charcoal filter which captures gases and eliminates unpleasant smells (in particular tobacco).
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page12 EN DISASSEMBLING/REASSEMBLING FILTERS Fig.5a Fig.5b Fig.5c Fig.5d Fig.5e Fig.5f Fig.5g Fig.5h Fig.5i Fig.5j Fig.
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page13 EN WARNINGS It is essential that you read these instructions carefully and comply with the following recommendations: • For your safety, this appliance complies with all applicable standards and regulations (Low Voltage, Electromagnetic Compatibility, Environmental directives, etc.). • This appliance is designed for domestic use only. It should not be used for industrial applications. • The warranty will be invalidated if damage occurs due to incorrect use.
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page14 EN - The filters, pre-filters and front are correctly installed (see "MAINTENANCE" section) => This appliance has a device that automatically cuts off the appliance if the front hood is not correctly assembled. Connect the power cord and press the start button (A).
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page15 EN MAINTENANCE It is important that you switch off the appliance with button (A) and unplug before any maintenance operation. You can clean the appliance with a slightly damp cloth. IMPORTANT: Never use abrasive products which could harm your appliance’s appearance. FILTERS This appliance has three types of filters: 1- Pre-filter 2 - Activated charcoal filter 3- HEPA filter For optimum performance of the appliance, only use filters provided by ROWENTA.
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page16 EN PARTICLE SENSOR The particle sensor needs regular and adequate cleaning (every 2 months); the following recommendations must be followed: 1. Clean the air inlet and outlet using a soft brush or hoover. 2. Open the sensor cover located on the right of the appliance. 3. Lightly wet a cotton bud and clean the glass and the dust inlet and outlet. Wipe using a dry cotton bud. IMPORTANT: The efficiency of the sensor may be reduced if not cleaned regularly.
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page17 EN SETTING THE PARTICLE SENSOR The appliance is pre-set to medium sensitivity. If the air quality remains poor after two hours in operation or very good for more than one hour when the air does not seem clean, the user can adjust the sensor sensitivity by following the instructions below. 1. When the air purifier is on, hold down the flow adjustment buttons for 2 seconds. 2 seconds 2. The flow light flashes in intervals of 0.5 seconds. 3.
RO_PURIFICATEUR_PU2120_EO 26/06/12 16:40 Page18 EN STORAGE When you are not using the appliance, store it in a dry place. IN THE EVENT OF PROBLEMS • Never dismantle your appliance yourself. A poorly repaired appliance can cause risks for the user. • Check the troubleshooting table below before contacting an approved Service Centre: Problem The appliance does not emit air. Check Solution • Is the power cord connected? Connect the power cord to a plug with the correct voltage.