Use and Care Manual
16
TIMER / DELAYED START
If the appliance is on: you can use this button to define the operating duration. Briefly press the button
to select the number of operating hours desired (1, 2, 4 or 8) and the appliance will automatically turn
off at the end of the selected period.
If the appliance is off: briefly press the button to set the appliance to turn on in a certain number of
hours (1, 2, 4 or 8).
3D PURE AIR FUNCTION (adjustable grid)
You can adjust the position of the air outlet grid manually, as desired. For an optimum, even flow of
purified air in the room, set the angle to 45°; for maximum comfort, set the angle to 90°.
MAINTENANCE
Always switch the appliance off with the button (8) and unplug it before conducting any maintenance
operation.
You can clean the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could damage your appliance’s appearance.
FILTERS
This data is based on an average use of 8 hours per day at speed 2.
The recommended frequency for cleaning and replacing the filters may vary depending on the duration
of use and the operating environment.
• A “HEPA” light indicates when the HEPA filter needs to be replaced.
The 'Odor' light display indicates when the carbon filter needs replacing.
• The NanoCaptur filter contains translucent granules which change color according to the formaldehyde
absorption rate. Refer to the color chart on the inside of the panel or the filter itself to establish the filter
saturation rate.Once the saturation rate has reached its maximum, the filter must be replaced. You have
to check the filter saturation rate every six months.
• The pre-filter can be re-used: remove the dust using a vacuum cleaner or wash with water.
CAUTION:
• The appliance's efficiency can be reduced if the pre-filter is not cleaned regularly.
• Never use a pre-filter that is still damp.
• The pre-filter is the only filter which can be re-used and washed with water. The HEPA, NanoCaptur
and active carbon filters cannot be cleaned and re-used. Never wash with water.
• To replace the filters, follow the instructions in the section « Disassembling/Reassembling filters ».
Press Ambient light Air quality indicator Control panel
1 Light up Light up Light up
2 Moderate light Moderate light Moderate light
3 Off Moderate light Moderate light
4 Off Off Moderate light
Filter Action Cycles
Pre-filter Clean Every 2 to 4 weeks
Active carbon filter Replace Every 12 months
HEPA filter Replace Every 3 years
NanoCaptur filter Replace
Color changing
(see Color chart on filter)
PU4020F0-PU6020F0_903452-01-V10.qxp_903452/0112/12/1410:06Page16