Operation Manual

- Move your appliance slowly over the bikini area, against the hair.
- For better efficiency of the appliance, remove the hair regularly using the brush or by
completely removing the accessory and blowing on it, in order to avoid jamming.
- At the end of the session, remove the bikini accessory with the plastic fitting at its base.
5. USING THE BIKINI HEAD (MOD. RF7360) AND COMBS
The bikini head (k) comes with two combs (3mm and 6mm) (L) which lift up the long hairs of
the bikini area so they can be cut by the blade.
Operating instructions:
- Remove the shaving head by pressing the release buttons on the head (E) and pull the head
gently upwards (fig 1).
- Fit in the bikini head, using the two hooks located at the back of the head, then swivel it until
it clicks. (fig 10&11),
- Fit the desired comb (3 or 6 mm) onto the bikini head (fig 7):
• If you want a hair length of about 3 mm, use the 3 mm comb.
• If you want a hair length of about 6 mm, use the 6 mm comb.
- At the end of the session, remove the comb using the plastic fitting at its base and slide it
along the bikini head.
- After use, remove the bikini head by pressing the release buttons on the head (E) and gently
pulling the head upwards (fig 12).
- To put the shaving head back on the appliance: insert the head using the two hooks located
at the back of the head, then swivel it until it clicks (fig 2&3).
6. USING THE BIKINI HEAD
without a comb for a neat bikini outline
If you want a close shave, use the bikini line trimmer head without a comb:
- Stop and unplug the appliance.
- Remove the comb (fig 8).
- Switch on the appliance.
- Hold the appliance at right angles to your skin and move it slowly against the hair.
- After use, remove the bikini head by pressing the release buttons on the head (E) and gently
pulling the head upwards (fig 12).
- Stop and unplug the appliance.
7. CLEANING AND CARE INSTRUCTIONS
Clean the shaver after each use!
• Dry cleaning
- Stop and unplug the appliance.
- Press both release buttons (E) and lift up the shaving head (fig 1)
- Open the shaving head by moving the blade release button (D) on the shaving head (fig 4.)
- Brush the shaving unit with the cleaning brush supplied. Also clean the area under the
cutting unit and brush clean the upper cover (fig 5).
• Cleaning with water
- Stop and unplug the appliance.
42
Not RF3330 1800112219.qxd:1800112219 5/12/07 14:44 Page 42