User manual
15
EN
Attaching / Removing / cleaning the comb.
If you want to clean the comb, you can remove it by following the diagram beneath.
Important, you must remove the comb when it’s cold in order to avoid getting burnt.
The comb can be cleaned in soapy water. Check that the comb is dry before tting it back on the straightener.
MY HAIR IS NOT STRAIGHTENED CORRECTLY:
• Have you been using your straightener in the right direction?
(see paragraph 5. HOW TO START USING YOUR STRAIGHTENER, 1- direction of use).
• Did you choose the right temperature?
(take a look at the table showing the temperature settings)
• Is the straightener producing any steam? NO
• Did you ll the reservoir correctly (see paragraph on lling the reservoir page 12) ?
If the level is lower than the minimum level, ll the reservoir and close the tongs for around
90 seconds until the steam comes out.
• Have you positioned the reservoir correctly (see paragraph on removing and tting the reservoir
page 12) ?
• Is the straightener at the right temperature? Wait until the gure representing the temperature
you have chosen has stopped ashing.
• Check that the steam cord hasn’t accidentally become stuck.
THE STEAM CAN’T BE SEEN:
• In a very moist environment, it’s possible that although you can’t see the steam it is still producing
the required eect.
THE STRAIGHTENER WON’T HEAT UP:
• Have you checked that the straightener is not in economy energy mode? (see paragraph on economy
energy mode page 14).
• Have you plugged in your straightener and pressed continuously on the ON/OFF button to switch it on?
YOU’RE NOT ABLE TO CHANGE THE TEMPERATURE OF YOUR STRAIGHTENER:
• You’re probably in locked mode (a padlock will be showing on the screen).
To unlock the straightener, press continuously on the + button or the - button.
THE TOP PLATE IS NOT STATIC:
• This is quite normal, the straightener is tted with a mobile plate so ensure more ecient straightening.
WARNING: For hygiene purposes and to avoid the risk of water leaking during storage, please assure you
empty the reservoir after use.
8. IF THERE’S A PROBLEM