800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page1 1800129621 - 48/13
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page2 Instruction for use EN www.rowenta.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page3 220-240 V 8* 7 110-120 V 3 4 2 5 1 6 * depending on model N BEFORE USE "Click" Fig.1 Fig.2 Fig.3 Fig.4 Fig.5 Fig.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page4 220-240 V 110-120 V Fig.6 a USE 50s 1push/ 4s Fig.7 Fig.8 Fig.9 ACCESSORY "Click" Fig.10a Fig.11b Fig.10b "Click" Fig.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page5 IMPORTANT SAFETY INSTRUCTIONS When using your appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT. To reduce the risk of contact with hot water emitting from the steam vents, check the appliance before each use by pressing the steam trigger. Make sure you direct the appliance away from yourself and others. Use the appliance for its intended use only.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page6 ÊUÊ,"7 / Ê / , / " Ê / / ÃÊ«À`ÕVÌÊÃÊÀi«>À>LiÊLÞÊ,"7 Ê 1 , / : www.rowenta.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page2 For dual voltage* appliance: a. Be sure the dual voltage selector is in the correct voltage position before operating. b. Before plugging in, read the information about dual voltage operation contained in the instruction section of this manual. c. This appliance was set at the factory to operate at 220-240 Volts. Refer to the operating instructions section of this manual for conversion to 110-120 Volt operation. d.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page3 Filling with water Steaming clothes Warning ! Never use 100%, distilled or demineralised water as this can cause the appliance to spit. Before removing or attaching the fabric brush, unplug your appliance and let it cool down. • Your steam brush has been designed to operate using untreated tap water.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page4 clothes slowly from left to right. The pad can be cleaned by brushing in the opposite direction right to left on a piece of old cloth. • Remove the lint pad from the steam brush by pulling it to the bottom - fig.10a. • For storage, attach the lint pad to the steam brush. Gently push the top of the lint pad into place until it snaps in - fig.10b. the frequency with which you use the EN appliance.
1800129621 DR6000 UK_110 x 154 02/12/13 11:40 Page5 IS THERE A PROBLEM ? Problems There is no steam. The appliance does not heat. Water spits. Possible causes Solutions The steam brush is not plugged in. Check that your appliance is correctly plugged in. The water tank is empty. Unplug your appliance and refill the water tank. You are using the appliance for When the appliance is new, press the steam trigthe first time. ger a few times in vertical position. The steam trigger has not been primed.