Operation Manual

34/40
GB
4.4 Troubleshooting
Fault Possible cause(s) Remedy
Tab. 3: Error diagnosis
Appliance does not
start.
The switch switches off
during operation.
The appliance is not
switched on.
The room temperature is
above the temperature set at
the thermostat.
The thermal overload switch
has triggered. The appliance
has exceeded the maximum
permissible temperature.
The room temperature is
above the temperature set at
the thermostat.
The thermal fuse has trig-
gered
Turn the heating level switch to
position "I" or "II".
Increase the thermostat tem-
perature.
Switch off the appliance by
moving the heating level switch
to position "0" and pull the
plug out of the socket. Allow
the appliance to cool down for
several minutes. Check the air
inlet and air outlet openings
and remedy the cause of the
overheating before restarting
the appliance.
Increase the thermostat tem-
perature.
Please contact the ROWI
Service-Team (Chapter 5)
Appliance does not
start.
No power or voltage too
low.
Make sure that the connector is
plugged into the socket. Check
the power supply voltage.