User's Manual

11
4.2.1.1 AC Power
The
ROXX E.SHOW mini TW+ / E.SHOW mini FC operates on any 100–260 V, 50/60 Hz AC mains power supply with
a maximum power consumption of 220W.
Connect the xture to AC power using the supplied cable or a similar one with Neutrik powerCON TRUE1 NAC3FX-W
or a compatible type, to ensure the correct ingress protection (IP).
For temporary installations, the mains cable must be tted with a grounded connector intended for exterior use. The
xture must be grounded/earthed and be able to be isolated from AC power. The AC power supply must incorporate
a fuse or circuit breaker for fault protection.
Warning!
Read “Safety Informations” starting on page 3 before connecting the xtures to AC mains power!
Do not connect the xture to an electrical dimmer system, as doing so may cause damage that is not
covered by the product warranty!
4.2.2. DMX Connection
The E.SHOW mini TW+ / E.SHOW mini FC is fully controllable by DMX (USITT DMX512-A standard, based on RS-
485) and RDM. It can be connected using either DMX cables or via the built-in LumenRadio CRMX wireless system.
4.2.2.1. Cable Connection
If using a cabled DMX system, connect the DMX IN cable to the input connector (male 5-pin XLR connector) and
DMX OUT cable to the output (female 5-pin XLR connectors). For outdoor installations, use only IP65-rated XLR
connectors.
Use shielded twisted pair cable designed for RS-485 devices. The cables are daisy chained between the xtures,
and up to 32 xtures can be connected to the same DMX link. Up to 300 meters (1000ft.) of cable is achievable with
high quality DMX cables. All DMX links must be terminated in the last xture by connecting a DMX termination plug
to the last xture’s 5 pin DMX out connector.
4.2.2.2. Wireless Connection*
E.SHOW mini TW+ / E.SHOW mini FC is equipped with a LumenRadio ™ Transceiver module.
This enables the xture to work with the following connectivity options:
Working in Receiver Mode: receive wireless DMX- and RDM Signals via CRMX
Working in Transmitter Mode: transmit DMX (1 universe) to other units via CRMX
Full Control via Bluetooth 5.0 and ROXX App
User
Manual
Wire Color (EU models) Wire Color (US models) Conductor Symbol
Brown Black Live L
Blue White Neutral N
Yellow / Green Green Ground (earth)
or
1DATA
GND
DATA -
DATA +
120 Ohm
+/- 5%
5
2 4
3
1DATA
GND
DATA -
DATA +
5
2 4
3
DMX Termination
on last xture DMX out
XLR pin out