Installation Instructions

14
12
Heat Bending using a Heat Blanket
Ÿ Place the two
cement boards side
by side on wooden
blocks to protect the
worktable from heat
damage.
Tool and Material Needs
Ÿ Heatcon HC99-300 Heat Forming Kit or Equivalent
Ÿ Two 10’ Pieces of fiber cement siding.
Ÿ Heat resistant gloves.
Ÿ Enough blocks of wood to raise the cement boards
off the work table.
Ÿ Template of radius desired.
Ÿ Lay one heat blanket
on each of the
cement boards.
Ÿ Place the material to
be heated on one of
the heat blankets.
Make sure the “X”
is facing toward the
material to be
shaped.
Ÿ Lay the second heat
blanket over the
material.
NOTE: The heating blankets must not touch each other.
Place scrap pieces of trim between blankets if necessary.
Heat Bending using a Heat Blanket
Tool and Material Needs
• Heatcon HC99-300 Heat Forming Kit or equivalent
• Two 10’ pieces of fiber cement siding
• Enough blocks of wood to raise the cement boards off
the work table
• Heat resistant gloves
• Template of radius
desired
How to:
• Place the two cement
boards side by side on
wooden blocks to
protect the worktable
from heat damage.
• Lay one heat blanket on
each of the cement boards.
• Place the material to be
heated on one of the heat
blankets. Make sure the “X”
is facing toward the
material to be shaped.
• Lay the second heat blanket
over the material.
NOTE: The heating blankets must not touch each
other. Place scrap pieces of trim between blankets
if necessary.