Installation Instructions

28
28
The multiple angles designed into the finish trim and the
gable trim allow for the adjustment of the pocket width
desired depending upon the application. However, if the
installation includes mitering two adjacent pieces of trim
together such as at the peak of a gable, it is important
that the trim be placed correctly when cutting as shown
in figure 9. A scrap piece of 3/4” thick material can be
used as a guide to making placement easier.
CUTTING MITERS ON GABLE TRIM
parallel to table
3/4” scrap
piece
Fig. 9
GableTrim
1 ¼”
GABLE TRIM
The gable trim is a suitable alternative to a standard trim
board if a small profile is desired.
Ÿ Measure from the soffit 1 1/4” and strike a chalk line.
Ÿ Install the panels aligning the ends with the line.
Ÿ Install the gable trim using Cortex or Pro Plug screws
and matching plugs. Place fasteners approximately
every 12”-16”.
28
The multiple angles designed into the finish trim and the
gable trim allow for the adjustment of the pocket width
desired depending upon the application. However, if the
installation includes mitering two adjacent pieces of trim
together such as at the peak of a gable, it is important
that the trim be placed correctly when cutting as shown
in figure 9. A scrap piece of 3/4” thick material can be
used as a guide to making placement easier.
CUTTING MITERS ON GABLE TRIM
parallel to table
3/4” scrap
piece
Fig. 9
GableTrim
1 ¼”
GABLE TRIM
The gable trim is a suitable alternative to a standard trim
board if a small profile is desired.
Ÿ Measure from the soffit 1 1/4” and strike a chalk line.
Ÿ Install the panels aligning the ends with the line.
Ÿ Install the gable trim using Cortex or Pro Plug screws
and matching plugs. Place fasteners approximately
every 12”-16”.
Gable Trim
The gable trim is a suitable alternative to a standard trim board
if a small profile is desired.
• Measure from the soffit 1 1/4” and strike a chalk line.
• Install the panels aligning the ends with the line.
• Install the gable trim using Cortex or Pro Plug screws
and matching plugs. Place fasteners approximately every
12”-16”.
Cutting Miters on Gable Trim
The multiple angles designed into the finish trim and the
gable trim allow for the adjustment of the pocket width
desired depending upon the application. However, if the
installation includes mitering two adjacent pieces of trim
together such as at the peak of a gable, it is important that
the trim be placed correctly when cutting as shown in figure
9. A scrap piece of 3/4” thick material can be used as a
guide to making placement easier.