Manualshelf

Installation Instructions

ManualsBrandsRoyal Building Products ManualsBuilding materialsRoyal® Building Products 1 x 2 x 8' White PVC Trim Board
21222324252627282930
29
29
Corners
Conceal Corner Board
Ÿ Outside corner areas should be made weather
resistant in accordance with building codes,
typically using flashing material or house wrap.
Ÿ Install the corner board leaving 1/8” gap between
the corner and any eve.
Ÿ Extend corner 1/4”minimum below sheathing.
Ÿ Fasten as described on page 8.
Ÿ Install siding in accordance with manufacturers
instructions.
Fasteners 16” OC.
Traditional Square
Corner
Flashing or wrap
10”min.
Rabbeted
Corner
Gap if required by
siding
⅜”
½”
Ÿ If more than one length of
corner is required, create a
rabbet joint.
Ÿ To allow for expansion and
contraction thru temperature
changes, do NOT glue this
joint.
Ÿ Paint the inside of the rabbet
as necessary.
29
Corners
Conceal Corner Board
Ÿ Outside corner areas should be made weather
resistant in accordance with building codes,
typically using flashing material or house wrap.
Ÿ Install the corner board leaving 1/8” gap between
the corner and any eve.
Ÿ Extend corner 1/4”minimum below sheathing.
Ÿ Fasten as described on page 8.
Ÿ Install siding in accordance with manufacturers
instructions.
Fasteners 16” OC.
Traditional Square
Corner
Flashing or wrap
10”min.
Rabbeted
Corner
Gap if required by
siding
⅜”
½
”
Ÿ If more than one length of
corner is required, create a
rabbet joint.
Ÿ To allow for expansion and
contraction thru temperature
changes, do NOT glue this
joint.
Ÿ Paint the inside of the rabbet
as necessary.
Corners
Conceal Corner Board
• Outside corner areas should be made weather resistant
in accordance with building codes, typically using flashing
material or house wrap.
• Install the corner board leaving 1/8” gap between the
corner and any eve.
• Extend corner 1/4” minimum below sheathing.
• Fasten as described on page 8.
• Install siding in accordance with manufacturers
instructions.
• If more than one length of corner is
required, create a rabbet joint.
• To allow for expansion and
contraction thru temperature
changes, do NOT glue this joint.
• Paint the inside of the rabbet as
necessary.