Installation Instructions

39
• Place the three sided section of the wrap around the
column. Make certain that the wrap is as plumb as
possible (shims may be necessary). Secure the wrap
to the column placing a weather
resistant screw at the top and at the bottom of the
column. Place the screws so they will be hidden by
the cap and base. If no caps or bases are going to
be added, two screws at both the top and bottom
should be installed. Cortex or equivalent screws and
PVC plugs can be used to achieve a
finished look. In this case, use at least two screws at
both the top and the bottom of the column.
• With the remaining wrap side laying on a flat surface,
run a small bead of clear PVC cement completely
along both joint edges.
35
• Place the three sided section of the wrap around
the column. Make certain that the wrap is as plumb
as possible (shims may be necessary). Secure the
wrap to
the column
placing a
weather
resistant
screw at
the top
and at the
bottom of
the column.
Place the
screws so
they will
be hidden
by the cap and base. If no caps
or bases are going to be added,
two screws at both the top and
bottom should be installed. Cortex or equivalent
screws and pvc plugs can be used to achieve a
finished look. In this case, use at least two screws at
both the top and the bottom of the column.
• With the remaining
wrap side laying on
a flat surface, run
a small bead of
clear PVC cement
completely along
both joint edges.
35
• Place the three sided section of the wrap around
the column. Make certain that the wrap is as plumb
as possible (shims may be necessary). Secure the
wrap to
the column
placing a
weather
resistant
screw at
the top
and at the
bottom of
the column.
Place the
screws so
they will
be hidden
by the cap and base. If no caps
or bases are going to be added,
two screws at both the top and
bottom should be installed. Cortex or equivalent
screws and pvc plugs can be used to achieve a
finished look. In this case, use at least two screws at
both the top and the bottom of the column.
• With the remaining
wrap side laying on
a flat surface, run
a small bead of
clear PVC cement
completely along
both joint edges.
35
• Place the three sided section of the wrap around
the column. Make certain that the wrap is as plumb
as possible (shims may be necessary). Secure the
wrap to
the column
placing a
weather
resistant
screw at
the top
and at the
bottom of
the column.
Place the
screws so
they will
be hidden
by the cap and base. If no caps
or bases are going to be added,
two screws at both the top and
bottom should be installed. Cortex or equivalent
screws and pvc plugs can be used to achieve a
finished look. In this case, use at least two screws at
both the top and the bottom of the column.
• With the remaining
wrap side laying on
a flat surface, run
a small bead of
clear PVC cement
completely along
both joint edges.
35
• Place the three sided section of the wrap around
the column. Make certain that the wrap is as plumb
as possible (shims may be necessary). Secure the
wrap to
the column
placing a
weather
resistant
screw at
the top
and at the
bottom of
the column.
Place the
screws so
they will
be hidden
by the cap and base. If no caps
or bases are going to be added,
two screws at both the top and
bottom should be installed. Cortex or equivalent
screws and pvc plugs can be used to achieve a
finished look. In this case, use at least two screws at
both the top and the bottom of the column.
• With the remaining
wrap side laying on
a flat surface, run
a small bead of
clear PVC cement
completely along
both joint edges.