Service manual

05-27
✰ Remove the Tappet cover.
✰ Remove the Allen screw, and the
bracket - join - hydraulic tappets.
✰ Gently pull out the 2 needle roller
pins holding the inlet and exhaust
hydraulic tappets.
NOTE: Remove Inlet tappet first and then
the exhaust tappet.
✰ Remove the exhaust and inlet
hydraulic tappets carefully from
Crankcase top side.
CAUTION :
Store the tappets carefully & right side
up as detailed earlier.
GEAR TRAIN REMOGEAR TRAIN REMO
GEAR TRAIN REMOGEAR TRAIN REMO
GEAR TRAIN REMO
VV
VV
V
ALAL
ALAL
AL
✰ Remove the bolt, copper washer, cap
pivot pin and “O” ring above the cam
plate pivot pin.
✰ Remove the 3mm roller locating pin.
✰ Remove Tappet cover by dismantling
4 Allen screws.
INLET tappet
EX. tappet
Engine Dismantling, Inspection & Assembly