Service manual

05-38
CRANKCASE RH
✰ Assemble Needle bearing for lay
shaft.
✰ Assemble NU 305 big roller bearing
after bearing spacer in LH Crank
case for crankshaft.
✰ Assemble 6305 - C3 bearing after 1st
circlip. Insert 2nd circlip then
bearing spacer in Crank case
LH as shown in Fig.
✰ Assemble sleeve gear ball bearing
(6007 R1/C3) and circlip.
NOTE : Ensure the rubber sealed face is
facing the FD sprocket side, while assem-
bling the 6007 bearing.
✰ Insert circlip and then assemble
crankshaft RH side needle roller
bearing into Crank case.
Engine Dismantling, Inspection & Assembly